Insulation removal for Melbourne homes and commercial buildings. We vacuum out old blow-in, loose-fill and batts, bag it on site and take it away, so your ceiling is clear for new insulation, rewiring or renovation.
Insulation removal is the first step when old ceiling insulation has slumped, gone mouldy, been soiled by rodents or simply stopped working. Our crew uses an industrial vacuum system that pulls material straight from your roof space into sealed bags outside. Nothing is dragged through your hallway, and the dust stays out of your living areas.
01Blow-in insulation removal is our most common job. Loose-fill settles, clumps and spreads dust through gaps and downlights. We vacuum it out completely, including material packed against eaves and around ceiling joists.
Get a quote →
02Ceiling batts lose thickness and value over time, especially after leaks. We lift out old batts by hand, bag them in the roof space and remove them without dragging debris through your home.
Get a quote →
03Opening up walls for a renovation or rewire? We strip out old wall insulation so your builder or electrician can start on a clean frame.
Get a quote →
04Offices, warehouses and retail fit-outs. We work around trading hours, follow your site safety rules and remove insulation from ceilings, ductwork and plant areas.
Get a quote →
05Insulation soiled by rodents, possums, birds or water damage can cause odours and poor air quality. We remove the contaminated material and vacuum the ceiling space clean.
Get a quote →
06Clear out the old and install new batts in one booking. We match the R-value to your roof and Victorian energy requirements, so you deal with one crew from start to finish.
Get a quote →
Insulation removal is dusty, cramped work above live wiring. We plan each job around your home: covering floors at the manhole, protecting cables and downlights, and leaving the roof space swept and ready for the next trade.
We check roof access, the type and depth of insulation, and any signs of mould, pests or asbestos.
You get a written price and a start date. No hourly rates and no surprises on the day.
We protect the manhole area, vacuum the material out to sealed bags and work around wiring and downlights.
We clear the roof space, take the waste away and send you before-and-after photos.
Old ceiling insulation removal makes sense when the material can no longer do its job, or when it gets in the way of work in the roof.
Cooler summers, warmer winters and a cleaner roof space before you re-insulate.
Clear old or damaged insulation between tenancies and keep the property compliant.
Strip ceilings and walls before demolition so trades start on a clean frame.
Clear roof access ahead of rewiring, solar, ducted heating or extension work.
Insulation removal for a standard single-storey Melbourne home usually takes one day. Larger roofs, double storeys, low pitches or heavy blow-in can take longer. We confirm the timeframe in your quote.
No. We vacuum the material straight from the roof cavity through a hose to sealed bags outside. We cover the floor at the manhole and clean up before we leave.
Most people stay home. The vacuum unit sits outside, so the noise is mostly outdoors. If anyone in the house has asthma or allergies, you may prefer to be out while we work.
If we suspect asbestos, we stop and recommend testing. Asbestos must be handled by a licensed asbestos removalist under WorkSafe Victoria rules, and we will tell you before any work goes ahead.
Yes. We can remove old insulation and install new ceiling batts in the same booking, matched to the R-value your home needs.
It is bagged on site and taken to an approved waste facility. You do not need to arrange a skip.
Insulation removal cost in Melbourne depends on the roof space, not a flat rate. We inspect first and give you a fixed price in writing.
Bigger and lower-pitched roofs take more time to clear.
Deep blow-in takes longer to vacuum than a single layer of batts.
Manhole size, storeys and roof framing all change the job.
Mould, rodent waste or water damage needs extra clean-up.